The dbtran utility crashes (terminates unexpectedly) when using the "-
it" flag. Has anyone experienced this? Is this a known issue?

On a side note, I should mention that the crash only occurs after a
database has been unloaded to Sybase 11 using the "-an" flag. If we
unload using the "-ar" flag, the dbtran utility works fine (although
the log comes out blank of course).

Any suggestions?

Hi Jonesy,

I have reproduced this issue on 11.0.1.2367 and can confirm the crash
behaviour of dbtran.

I was able to crash dbtran by reloading the 11.0.1.2367 demo database
using -an, then trying to dbunload that resulting database for
'customer,product' in dbunload -it.

I have submitted CR #613637 to engineering for investigation into this
crash.

Thank you for the bug report.

Regards,

On 1/6/2010 3:26 PM, Jonesy wrote:
--
Jeff Albion, Sybase iAnywhere

iAnywhere Developer Community :
http://www.sybase.com/developer/libr...ere-techcorner
iAnywhere Documentation : http://www.ianywhere.com/developer/product_manuals
SQL Anywhere Patches and EBFs :
http://downloads.sybase.com/swd/summ...&timeframe =0
Report a Bug/Open a Case : http://case-express.sybase.com/cx/

Thanks for the quick reply, Jeff.

This has been fixed (11.0.1.2374):

http://search.sybase.com/kbx/changer...?bug_id=613637

Regards,

On 1/7/2010 11:56 AM, Jonesy wrote:
--
Jeff Albion, Sybase iAnywhere

iAnywhere Developer Community :
http://www.sybase.com/developer/libr...ere-techcorner
iAnywhere Documentation : http://www.ianywhere.com/developer/product_manuals
SQL Anywhere Patches and EBFs :
http://downloads.sybase.com/swd/summ...&timeframe =0
Report a Bug/Open a Case : http://case-express.sybase.com/cx/