Hello everyone!

I have a fact table measure that is a percentage value loaded from my source
system (I don't have these underlying facts)

So, when a user drills to the lowest level of the cube, only then does
showing the leaf information make sense.

A good case for selecting the AggregateFunction set to None.

However, when I drill down in the browser, the value is always NULL.

A side question, to diagnose, I wanted to "drill to detail" to see the
underlying fact table, like AS 2000, but couldn't find a way to do that
either.

Any suggestions?

Thanks, Bill

Bill,

Did you ever get a response to your question? I have the same issue.