Looking for some advice on an issued that just popped up. Not sure if
this was the cause but after applying MS04-011 and 012 MSDTC will not
run on the primary Node. Main application error message is:

"MS DTC was unable to start because the installation of was not
configured to run on a cluster. Please run comclust.exe and restart
MS DTC. Error Specifics: .\msdtc.cpp:825, CmdLine:
C:\WINNT\System32\msdtc.exe, Pid: 2160"

Just curious if anyone has run comclust again after MSDTC has been
setup and if this will cause any issues. I think that it shouldn't
but it doesn't hurt to check.

Thanks,
Derek

Did you run comclust on both nodes of the cluster?

If so you should be able to run comclust -r on the primary node while the
resource is on the secondary node. After this you can run comclust on this
node. This should resolve the problem.

Rand
This posting is provided "as is" with no warranties and confers no rights.

Rand - Yes I ran comclust on both nodes at initial setup. I'll give
comclust -r a try tonight.

Thanks,
Derek