Is there a command that can give me the IP address of anything
connected to my box.

I am using MVBASE with all patches load...

is ther a command

LISTLINES----does not give me the IP

There is a command from DOS or UNIX command level,
netstat, and you would use it "netstat -a"<cr>, or you could use
it as follows: "netstat -a > ns_out_hhmm.txt" <cr> where
hh = 2 digit hours
mm = 2 digit minutes
This way you can log things over time, and your "ns_out_hhmm.txt"
is a simple re-directed output text file you can refer back to.

HTH

<shaun (AT) jitmall (DOT) com> wrote

IIRC it does however show the PC name (as in Telnet: [PCNAME])

You could find the ip address by pinging the name I suppose. I don't know
if this will work 100% of the time though.

A caveat though... though I've not used versions of mvBASE pase 1.3.1, the
LISTLINES command has a horrible tendency to hang for ages when you run it
when a port is "hung". This was so bad that we always used to instruct our
helpdesk staff to avoid listlines if they could at all help it.

Regards
Simon
<shaun (AT) jitmall (DOT) com> wrote

Thanks for the netstat works fine.