After loading D3 7.4.0 on FC3, the install process creates the disk
statement in pick0 as a raw partition. But FC3 does not have the raw
command, so I comment out the raw part of the disk statement. I make
sure that the partition size in the disk statement is divisible by 4.
The partition type is 'd3'.

After starting D3 -0, I can load abs, but when loading files via the F
option I get the following error:

Monitor instruction diagnostics
Passed.
Flush process started (pid 3105)
Terminate process 0, pid 3208
PICK installation failed, illegal activation

Any Clues? I have also tried using a linux file in the disk statement
with the same result.

Scott Ballinger
Pareto Corporation
Edmonds WA USA
206 713 6006